Most of the time, companies will spend lots of money to purchase their forklifts. It is essential, therefore to take good care of your equipment to protect your investment into the long run. It is really a great idea to know the procedures which are undertaken during maintaining and taking care of this machinery.
Among the best ways to tell how good the engine is working is by starting the forklift up and listening closely to see how it works. For example, if there are any misses or knocks, the equipment is faulty and this must raise several concerns. In addition listen carefully for any squealing noise that come from the belts as these sounds will provide you with a wealth of information.
When performing maintenance, some of the main parts you would have to pay attention to include the safety warning devices, horn, the lights, the gauges and the overhead guard. Any faulty parts or burnt out light bulbs have to be replaced as soon as they are noticed. It is also vital to inspect the wiring.
The battery compartment terminals must be cleaned after the above parts have been inspected thoroughly. If the terminals are not clean, be sure to clean them well. Each and every battery cell has to be inspected so as to ensure the fill level is topped up to the regulated amount.
The next step is to drain all of the oil out of the equipment and after that change the filters. The fuel filters, hydraulic filter and the transmission filter must be replaced regularly. Prior to fitting them, be sure to write the date on the new filters by using a permanent marker in order to keep track.
When the oil change has been done and new filters have been fitted, visually check the drive axle from underneath the machinery. Be sure to grease the axle if there is any grease fitting. Check the engine belts for any cracks or frays. If you find any, fix the issue accordingly. Then, check each and every other component of the equipment like the wheels. If any type of issue or fault is detected, be sure to address it immediately in order to make sure the equipment is working at its safest and optimum levels.